Stability of environment - stability of results of operation!

• The system can operate only in climate controlled room with parameters:
  • Air humidity not more than 60%; moisture condensation is not allowed;
  • Temperature should be not higher than 30С; it is advisable to equip the room with an air-conditioner capable to maintain air temperature in range 21-24С.

• Minimal dimensions: 3.5x4m
• Minimal doorway: 80cm
• The floor should have a rigid and smooth covering (tile):
  • to allow loading of 500 kg (system) and 350 kg (the personnel);
  • to reduce a room dust content to a minimum.
• The surface of a ceiling and walls should not allocate a dust, carpet coverings is prohibited.
• If room painting was made, system installation can be made only after definitive drying of a paint (in 2-3 weeks).
• The room should be equipped with exhaust and combined inflow-exhaust ventilation. Air stream should not get to a working zone, it can lead to deviations in system work.
• The door of the room must be equipped with a blocking lock, a sign: “Danger, laser in operation” and a mark of laser hazard is demanded.
• The room must be maintained in accordance with general hygienic requirements for operation rooms.
• The fire extinguisher should be in an easily available place.
• Recommendations for locating the system are given on the picture.

Notice: Operation the system in the room with excessive humidity can lead to improper results.

Electric requirements

Single-phase electric line with the following parameters: 220 V, 50 Hz, 10 A. Plug type: European.

Ventilation requirements

• the exhaust and combined inflow-exhaust ventilation should provide tenfold change of volume of air in a room for an hour,
• System should be connected to the exhaust system of the room, separated from the central ventilation system.

The excimer laser uses a gas premix with the low maintenance of fluorine. The vessel with a gas mix is installed in a hermetically compartment of laser system.

The cleaner or exhaust ventilation should be turned on comfortably by the switch located on a wall near the exit.

If there is a heater indoors or the air return from conditioner, the head of patient should be in a position preventing from the contact with a direct stream of hot air.